Front load dryer
front-load-dryer
dresses furniture:dryer
— and nothing else. Appearance is invisible to the drawing set, so adding this changes no
plan, no section and no elevation.
- 8of 500 meshes
- 2slots
- 1finish
Drag to orbit · scroll to zoom
$frame
$accent
This definition leaves
$frame and $accent
open, and a look line fills them. Every combination is one body — same
geometry, same selector, same sheets — so the block below rewrites itself as you pick.
Only materials are slottable: a size would have to agree with the plan, so it stays on
the entity.
Paste this
Every part: the 2 materialdefs the body resolves to, then the definition. Copying the lookdef alone still compiles and still validates — it just renders grey.
{"t":"materialdef","id":"pal-ceramic","of":"ceramic","value":92}
{"t":"materialdef","id":"pal-charcoal","of":"paint","value":20}
{"t":"lookdef","id":"front-load-dryer","for":"furniture:dryer","desc":"Front-loading tumble dryer with circular door and control panel.","slots":{"frame":"pal-ceramic","accent":"pal-charcoal"},"preview":{"projection":"perspective","azimuth":34,"elevation":15,"fov":34,"margin":1.04},"body":{"type":"Group","children":[{"type":"Mesh","material":"$frame","geometry":{"type":"RoundedBoxGeometry","width":0.69,"height":0.95,"depth":0.7,"radius":0.025,"segments":3},"position":[0,0.5,-0.025]},{"type":"Mesh","material":"$frame","geometry":{"type":"RoundedBoxGeometry","width":0.69,"height":0.05,"depth":0.7,"radius":0.018,"segments":3},"position":[0,0.975,-0.025]},{"type":"bimtex:Run","count":2,"from":[-0.135,0.00625,-0.145],"to":[0.135,0.00625,-0.145],"children":[{"type":"Mesh","material":"$accent","geometry":{"type":"BoxGeometry","width":0.08,"height":0.025,"depth":0.08}}]},{"type":"Mesh","material":"$frame","geometry":{"type":"RoundedBoxGeometry","width":0.62,"height":0.13,"depth":0.035,"radius":0.012,"segments":3},"position":[0,0.88,0.3425]},{"type":"Mesh","material":"$accent","geometry":{"type":"TorusGeometry","radius":0.225,"tube":0.025,"radialSegments":14,"tubularSegments":28},"position":[0,0.52,0.35]},{"type":"Mesh","material":"$frame","geometry":{"type":"CylinderGeometry","radiusTop":0.2,"radiusBottom":0.2,"height":0.04,"radialSegments":24},"position":[0,0.52,0.355],"rotation":[1.5708,0,0]},{"type":"Mesh","material":"$accent","geometry":{"type":"RoundedBoxGeometry","width":0.13,"height":0.018,"depth":0.02,"radius":0.007,"segments":3},"position":[-0.12,0.67,0.365]},{"type":"bimtex:Run","count":5,"from":[-0.08,0.435,0.352],"to":[0.08,0.435,0.352],"children":[{"type":"Mesh","material":"$accent","geometry":{"type":"RoundedBoxGeometry","width":0.035,"height":0.012,"depth":0.015,"radius":0.004,"segments":2}}]}]}}Or take the whole pack, which brings every entry and every material at once:
cat packs/interiors.ndjson model.ndjson > dressed.ndjson